I’ve had a couple of questions about how I steam-finish my yarns – which is a little funny to me because I only just sort of muddled my way into it out of necessity for this project! So I thought I’d take some photos and explain my process in case it helps anyone else. This is the good process, by the way – not the one that resulted in scorch marks!
First, make sure your yarn has room to breathe. Don’t be too tempted to put lots and lots of yarn into your steamer in one go, because then the steam won’t make it to all the strands, and additionally if you’re steaming to bring out the bloom, you want to make sure there’s room for the strands to expand to their fullest potential.
I used a stock pot with a couple of inches of water in the bottom, and a pasta colander. Make sure your yarn isn’t going to be sitting in water; but also, you want to be sure that the pot won’t boil dry. Now, the colander doesn’t sit snugly in the pot because of the handles, so I had to seal the gap with a couple of tea towels and a couple of tissues. (Yes, they were clean, hehe.) This is the setup:
The yarn I was steaming this time around was the Hedgehog yarn, which I needed to puff out as much as it possibly could. So I spun the 4oz of polwarth in 1oz lots, then plied them into two lengths of yarn that were about 55g each. That left plenty of room in the colander:
Then I brought the water to the boil and popped the yarn into the colander. With the lid back on, the steam bath was all a go, and I let it sit in there for three or four minutes. Then, wearing rubber gloves!!!, I turned the yarn over and put the lid back on for another couple of minutes. Done! And here’s the result – these two skeins started out the same size. The skein on the bottom of the photo has been steamed, the one at the top hasn’t.