It never ceases to amaze me, how many different ways there are to muck around with fibre. See, I could, if I wanted, just spin straight from these batts. But it would be more difficult to get the effect I want, and to get a nice even yarn (not that it’s turning out to be all that even anyway – singles I hate you!).

So. I have found that for what I’m trying to do, it’s easier to spin from rovings than batts – they’re airier and come out less lumpy. To this end, I sat down to process half the fibre I’ve got set aside for this yarn. First I stripped the batts, tearing them lengthways into narrower batts. Then I pulled them through my dodgy DIY diz, drafting as I went to loosen the fibres and get more air into the rovings. Each roving was then wound into a little rosette.

Stripped batts, diz and rovings

One of the batts had fairly pronounced sections of different colours and textures. Because I’m spinning quite a fine yarn, and it’s going to be a single-ply, this could result large sections of my green being either bright shiny bamboo, or dark brown wool, or annoyingly tufty camel down. I want a more cohesive, mixed yarn, so I stripped that batt quite widely, into only four pieces.

Roughly carded batt - I need the colours to mix a bit more

Then I dizzed them extra carefully, stretching out the sections of bright bamboo or dark wool etcetera, as best I could, to end up with a more mixed roving.

Carefully dizzing the wide batt section

Fairly well mixed roving

And voila! Lots of little parcels of rovings, all ready to spin. But for today, I’ve spent hours chained to the wheel already so I’m not going to start on it just now . . .

Fluffy little roving flowers